2-Seater Semicircular Metal Tree Bench

We did our best to put this together. There were faults with the fittings and the bolts were also too short to use the washers. No holes drilled in two places so the bolts couldn’t be used at all. Can not be sat onsafely

The screws fell out after a few weeks needed to get someone to re do it. After that it’s fine got a compliment saying it looked good around my tree

Its really lovely. It took a bit of putting together. I found the easiest way was to slot the seat together then turn it over and rest it on the v corner of the kitchen table, then attach the legs. You have to make sure the 3 seat panels that make up the back of the seat, are the correct way up as its easy to place them upside down, the slim end should go to the top of the seat. The top brace bit is the tension holding all the seat together and so the legs don't spray out all over (like Bambie!) I unfortunately put them in upside down at first lol, and couldn't understand why the screw holes where in the wrong place. Anyway after much faffing (and a few obscenities) I got it together. Its so lovely. x

Looks good set up and was delivered a week earlier than expected

Thought it would have been wider for larger tree