The 12' x 30'' / 3.66m x 76cm Fast Set Pool Set by Bestway is a great family swimming pool. It sets up in only a matter of minutes on a flat surface as only the top ring needs to be inflated; the body of the pool has a liner that lifts when you fill the pool with water. It also comes with a flow control drain valve, allowing it to be drained quickly at the end of the season. The Fast Set Pool is constructed of tough Tritech material, making it extremely durable and guarantees to keep the family swimming for years to come!
Installation :
The pool must be set up on a completely flat and level surface. Please do not install the pool if the surface is inclined or sloped.Â
The selected location has to be capable of uniformly supporting the weight for the entire time the pool is installed, moreover, the location must be flat and must be cleared of all objects and debris including stones and twigs.Â
We recommend positioning the pool away from any objects children could use to climb into the pool. Position the pool near an adequate drainage system to deal with overflow or to discharge the pool.
Dismantling the Pool :
Unscrew the drain valve cap counter-clockwise and remove.
Connect the adaptor to the hose and put the other end of the hose in the area where you are going to drain your pool. (Check local regulations for drainage by-laws).
Screw the control ring of the hose adaptor clockwise onto the drain valve. The drain valve will be open and water will start to drain automatically. Open the drain valve to the maximum position.
Deflate the top ring by squeezing the air valve.
When the top ring is fully deflated, press the top ring down, and tilt it to drain the pool easily. Completely drain the water in the pool.
When draining is finished, unscrew the control ring to close the valve.
Disconnect the hose.
Screw the cap back onto the drain valve.
Air dry pool.
Repair :
In the event of a leak, patch your pool using the underwater adhesive repair patch provided. You can find the instructions in FAQs on the support section of our website, www.bestwaycorp.com.
Cleaning and Storage :
Please remove all the accessories and spare parts of the pool and store them clean and dry.
Once the pool is completely dry, sprinkle with talcum powder to prevent the pool from sticking together, and fold the pool carefully. If the pool is not completely dry, mould may result and will damage the pool liner.
Store liner and accessories in a dry place with a moderate temperature between 5ºC / 41ºF and 38ºC / 100ºF.
During the rainy season, pools and accessories should be stored as per the above instructions also.
Improper draining of the pool might cause serious personal injury and/or damage to personal property.
We strongly recommend the pool is disassembled during the off-season (winter months). Store in a dry location out of children’s reach.
